Release Tribus Solo Miner for Acorns

Dream

Administrator
Staff member
Administrator
Joined
Sep 10, 2018
Messages
35
Likes
38
#1
Please do not use the ZP miner after flashing the Tribus miner it can cause significant issues. Tribus has a much higher profitability and there's no reason to continue using the ZP miner.
Sample BAT:

Code:
AcornMiner.exe tribus.mine.zergpool.com 8533 LTCWALLETADDR workerName c=LTC,ID=workerName,m=party.acornie 180
New Update: Mostly ease of use / quality of life changes with an okayish documentation and script coming with a restarter now, so will be easier for newcomers to get started.

Another update: "Hot single-phase VRMs in your area! Click here to find them!"

Another ONE:
- Safer flashing: reworked procedure with extra safety checks.
- Flashing is opt-in instead of opt-out. No more dangerous auto-magic
- Forceflash's knock-off version is here. Check out recovery .bat / .sh
- Silly clock syndrome is gone, not aiming for the moon anymore
- Watchdog is here to terminate stuck miners.

Please do not use the ZP miner after flashing the Tribus miner it can cause significant issues. Tribus has a much higher profitability and there's no reason to continue using the ZP miner.
 

Attachments

Last edited:

peacefmind

Newcomer
Member
Joined
Dec 15, 2018
Messages
2
Likes
0
#4
For some reason will not flash FW heres output:
start.sh
I/LOGGER : Log level set to Info
I/Miner : Starting miner
I/Miner : Scanning for devices...
I/DMA_FILE : card0 - 4
I/Miner : Found 1 SQRLDMA devices:
E/Miner : Device 1: 215+ (0008948664b0485c:0000001c) running Zen protocol (2) bitstream Version 0.012 is not compatible
I/Miner :
I/Miner : ************************************************************
I/Miner : * WARNING! *
I/Miner : * The program may flash devices determined to be in need *
I/Miner : * of flashing. A power cycle is needed after flashing. *
I/Miner : * *
I/Miner : * Press 'y' to consent to flashing. *
I/Miner : * Press 'n' to skip flashing. *
I/Miner : ************************************************************
I/Miner :
Waiting for 30 seconds.........................
E/Miner : The core temperature of device 1 is 0.00 *C, which exceeds the flashing safety threshold. Refusing to flash
E/Miner : No device is ready for mining, exiting
Restarting the miner in 10 seconds...
I figure it out, did not use "sudo" :)
with clock 180 my 215+ cooking? What is your settings guys? I'm getting 31.25Mh/s with 125 clock?
 
Last edited:

LokarBOA

Newcomer
Member
Joined
Oct 25, 2018
Messages
5
Likes
8
#5
The cooking message means it's throttling the acorn to keep it stable. Either your voltage is falling too low or your temps getting too high. Look on the output which readouts are red/yellow and it will give you an idea what the problem is. If it's your VRM temps too high or voltage too low you can try adding a heatsink on the VRM chip or some thermal pads underneath to try and keep it cooler.
 
Top Bottom